Guys, Check out edsonmarine.com/Captain-Q. There are some videos to help. Good luck and Fair Seas.
- Welcome to Pearson 365 and 367.
This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.
Pages1
#1
Pearson General Non-Mechanical System Maintenance and Repair / Re: Steering cable question
January 02, 2023, 07:07:02 PM #2
The Rebirth Of Maruska as seen in Good Old Boat Magazine / Re: Stern Ladder
November 03, 2022, 12:06:06 PM
Dale, my email is halloa@charter.net Thanks so much for your effort.
#3
The Rebirth Of Maruska as seen in Good Old Boat Magazine / Re: Stern Ladder
November 01, 2022, 05:49:58 PM
Dale, did you ever get the stern ladder drawings created? I would love to start working on a new ladder. Thanks.
#4
The Rebirth Of Maruska as seen in Good Old Boat Magazine / Re: Stern Ladder
May 28, 2022, 06:53:09 AM
Dale, You are The MAN. I would appreciate the measurements because I like the idea of extended steps. Especially as we age LOL.
#5
The Rebirth Of Maruska as seen in Good Old Boat Magazine / Re: Stern Ladder
May 26, 2022, 07:55:03 PM
Dale, I really like what you did for a stern ladder. Could you send me drawings?
#6
Pearson 365/367 Mechanic Shop / P365 W40 Cooling Hull Ftg
April 28, 2022, 06:15:06 AM
I have searched for this topic without an answer. The vents for the strainer hull fitting on my boat is facing aft. Most boats I have seen have them facing forward. The boat has been on the hard since before I bought her (Hull #80) and the previous owner didn't have a clue. I am assuming the engine ran fine in that configuration but cannot obtain previous owners advice. Was there a reason for the vent to be facing aft or should I correct it to face forward? In actuality, i have two strainer hull fittings facing aft. I am just trying to sort out the thru-hulls on the boat.
Pages1