New Board:  Forum Support (Below Chandlery). Forum Support to submit any questions.

Main Menu

Show posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.

Show posts Menu

Messages - John Childs

Guys, Check out There are some videos to help. Good luck and Fair Seas.
Dale, my email is  Thanks so much for your effort.
Dale, did you ever get the stern ladder drawings created? I would love to start working on a new ladder. Thanks.
Dale, You are The MAN. I would appreciate the measurements because I like the idea of extended steps. Especially as we age LOL.
Dale, I really like what you did for a stern ladder. Could you send me drawings?
I have searched for this topic without an answer. The vents for the strainer hull fitting on my boat is facing aft. Most boats I have seen have them facing forward. The boat has been on the hard since before I bought her (Hull #80) and the previous owner didn't have a clue. I am assuming the engine ran fine in that configuration but cannot obtain previous owners advice. Was there a reason for the vent to be facing aft or should I correct it to face forward? In actuality, i have two strainer hull fittings facing aft. I am just trying to sort out the thru-hulls on the boat.